The GradedAppliance Hub

Samsung LE on a washer dryer

Leak detected — water has been found where it should not be.

Verdict

Needs an engineer

Mains electrical, gas or sealed-system work

Urgency
Urgent

About 37 min to work through

Typical cost

£75–£220

DIY: £18–£60 in parts

What LE actually means

Samsung machines detect water in the base and shut down to prevent a flood. Treat this the same way as a Bosch aquastop trip: isolate the machine and find the leak rather than resetting it and running another cycle.

Before you start

  • Electrical safety: Standing water inside a mains appliance. Unplug at the wall before anything else.

  • Water: Turn off the supply tap. A slow leak left running will damage flooring.

What causes it, most likely first

  1. Split door seal

    Most likely

    The rubber boot perishes and splits low down where water sits, so it leaks only when full or spinning.

    Door seal / bellows£18–£50 for the partDIY with care

  2. Leaking filter housing or loose filter cap

    Common

    A cross-threaded or perished filter seal drips steadily into the base tray.

  3. Overflowing detergent drawer housing

    Common

    A scaled-up drawer housing backs up on fill and runs down the inside of the cabinet. Look for detergent residue down the front left.

  4. Split internal hose or sump

    Occasional

    Internal hoses harden and crack with vibration. Finding which one needs panels off.

  5. Bearing seal failure

    Occasional

    Water past the shaft seal runs down the back of the tub. Usually preceded by months of roaring on spin, and often the end of the machine's economic life.

    Drum bearing kit£25–£70 for the partEngineer

How to fix it, step by step

  1. Isolate immediately

    Unplug at the wall and close the supply tap. Do not keep resetting to get another wash out.

    2 min

  2. Drain down and dry the base

    Empty the drum through the emergency hose, then with a helper tilt the machine gently back onto its rear feet over towels to empty the base tray.

    15 minTowels, Shallow tray

  3. Check the obvious leak points

    Peel back the outer lip of the door seal and feel round the lower half for splits. Check the filter cap seats squarely with an intact seal. Look for scale and sludge in the detergent drawer housing.

    15 minTorch

  4. Book an engineer if nothing is obvious

    Anything further means panels off and live testing to find the source. Quote the LE code when booking.

    5 min

Need an engineer for this LE?

We list 4 washer dryer repair businesses across the UK, 3 of which are Samsung-authorised. Diagnostic callouts typically start around £55, and many will put that towards the repair if you go ahead.

Find washer dryer engineers near you

Parts you might need

Typical UK prices for the part alone, before fitting. Worth knowing before you accept a quote — the part is often a small share of what a repair is priced at.

  • Door seal / bellows

    The flexible rubber boot between the door and the tub. Splits in the lower half leak only on fill or spin, which makes them easy to miss.

    £18–£50

  • Drum bearing kit

    The bearings the drum spins on, plus the shaft seal. Replacing them is a full strip-down and is often the point at which a repair stops being worth it.

    £25–£70

Worth repairing, or replace it?

At the top of this range the repair costs a significant share of a graded replacement, which typically starts around £280. Worth getting the quote first, then deciding — on a machine under about five years old a repair usually still wins.

Work out if it's worth fixingCompare graded washer dryers

Related problems

Other Samsung washer dryers codes

All Samsung washer dryers fault codes