Candy E07 on a washing machine
Motor fault — the drum is not turning as the control board expects.
The same code appears on Hoover machines — they share the same control platform.
Needs an engineer
Mains electrical, gas or sealed-system work
About 30 min to work through
£85–£250
DIY: £8–£160 in parts
What E07 actually means
The board commanded the motor and the speed feedback did not match. That can be a physical obstruction, worn brushes, or a fault in the motor or the board section driving it. Rule out a jammed drum yourself, then hand the rest over.
Before you start
Electrical safety: Motor and board work involves mains voltages and a capacitor that can hold charge. Unplug before removing any panel.
What causes it, most likely first
Object jammed between drum and tub
CommonAn underwire or coin wedged behind the drum physically stops it turning.
How to check: With the machine unplugged, turn the drum by hand — it should spin freely through several turns.
Worn motor carbon brushes
CommonWorn brushes make intermittent contact, so the machine washes but will not reach spin speed. Often accompanied by a hot carbon smell.
Motor carbon brushes£8–£22 for the partDIY with careSnapped or slipping drive belt
CommonA perished belt jumps the pulley — the motor spins freely while the drum sits still.
Drive belt£8–£22 for the partDIY with careFailed tacho or motor
OccasionalThe speed sensor fails so the board sees no rotation regardless of what the motor is doing.
Drive motor£60–£160 for the partEngineerControl board motor triac failure
OccasionalThe board component switching power to the motor fails. Needs live testing, and the board is the most expensive part in the machine.
Main control board (PCB)£70–£220 for the partEngineer
How to fix it, step by step
Unplug and turn the drum by hand
Rotate through several full turns both ways. Free and quiet is good; a hard stop means an obstruction, a deep rumble points at bearings.
5 minCheck for a foreign object
Shine a torch through the drum holes while turning it slowly, looking for wire or metal wedged behind. Check the pump filter too.
10 minTorchPower-cycle and try an empty spin
Switch off at the wall for a minute, restore power, and run a spin-only cycle on a bare drum.
10 minBook an engineer with the code
E07 points at the drive system. Quoting it means they arrive with brushes and a meter. Get the full quote before agreeing, especially on an older machine.
5 min
Need an engineer for this E07?
We list 83 washing machine repair businesses across the UK, 30 of which are Candy-authorised. Diagnostic callouts typically start around £55, and many will put that towards the repair if you go ahead.
- 0115 8719265NottinghamSame day
- 0800 037 4915London
- 07407 734204Bonnybridge
Parts you might need
Typical UK prices for the part alone, before fitting. Worth knowing before you accept a quote — the part is often a small share of what a repair is priced at.
Motor carbon brushes
Two sacrificial carbon blocks that carry current into a brushed motor. They wear down over years and are a cheap, planned replacement.
£8–£22Drive belt
Links the motor pulley to the drum pulley on belt-driven machines. A snapped belt gives you a motor that runs and a drum that does not.
£8–£22Drive motor
The motor that turns the drum. On most machines a genuine replacement costs enough to trigger a repair-or-replace decision.
£60–£160Main control board (PCB)
The appliance brain. Genuine boards are expensive and often need configuring to the model, so this is rarely a DIY part.
£70–£220
Worth repairing, or replace it?
At the top of this range the repair costs a significant share of a graded replacement, which typically starts around £200. Worth getting the quote first, then deciding — on a machine under about five years old a repair usually still wins.